HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 282

2 fruReplace fruReplace Interactive interface to replace a field replaceable unit (FRU). Synopsis frureplace fru Description Use this command to guide the user in replacing a FRU. The command automatically performs the necessary backup and restore (steps to accommodate the replacement). The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This the following operand is required: fru Specify the type of hardware component being replaced. WWN is the only supported value, specifying the replacement of the WWN card. Examples To replace the World Wide Name card: switch:admin> frureplace wwn This is the WWN card hot swap interface. Continuing from this point will require the whole process to be completed. If this process is not complete due to a power cycle, or CP failover, please follow the recovery procedure in Core Switch WWN Card Removal and Replacement document. Do you wish to continue [y/n]? y Backing up WWN card data, please wait about 25 seconds for further instruction. Please install the new FRU now. If this session lost for any reason, please re-enter the frureplace command and follow the instructions to complete the operation. Please enter the word `continue' after the new WWN card has been installed: continue Restoring the information to the replacement FRU now, please wait about 20 seconds to complete Verifying the replacement FRU now... WWN card hot swap is now complete. FRU replacement completed successfully! See Also none 250 Fabric OS Command Reference Manual 53-1000436-01