HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 48

2 ag ag Enables and manages the Access Gateway(AG) mode to perform AG specific operations. Synopsis ag --show ag --modeshow ag --modeenable ag --modedisable ag --mapshow [N_Port] ag --mapset [ ] ag --mapadd [ ] ag --mapdel [ ] ag --failovershow [N_Port] ag --failoverdisable ag --failoverenable ag --failbackshow [N_Port] ag --failbackdisable ag --failbackenable Description Use this command to enable and disable Access Gateway mode, to display the current configuration state, to configure and display the failover and failback policies, and to display the F_Ports to N_Port mapping. These configuration changes are saved persistently as config keys. Use portcfgnport to set a port as N_Port. Operands This command has the following operands: --show Displays detailed information regarding the configuration of the Access Gateway. This includes all N_Ports and F_Ports that are currently online, failover and failback settings as well as any online F_Ports that are currently mapped to N_PortsDisplays the N_Ports and F_Ports that are currently online, if failover is enabled, and shows their mapping. For Failover 1=enabled and 0=disabled. --modeshow Displays the current operating mode of the switch, either Access Gateway or native fibre channel switch mode. --modeenable Enables Access Gateway mode for a switch. Note: Long distance mode settings should be cleared for all ports on the NPIV edge switch to which the AG is connected. Otherwise, the NPIV switch port will display the long distance port type along with the F_port. --modedisable Disables Access Gateway mode for a switch. Note: After AG mode is disabled, the switch will come online with default zone access set to "No Access". In order to merge the switch to a fabric you must set the default zone to "All Access" and disable/enable the E_Port". --mapshow [N_Port] 16 Fabric OS Command Reference Manual 53-1000436-01