HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 56

2 agtCfgDefault Trap Recipient Severity Level The trap severity level is associated with each trap recipient IP address. The event trap level is in conjunction with the event's severity level. When an event occurs and if its severity level is at or below the set value, the SNMP event traps (swEventTrap, swFabricWatchTrap, and connUnitEventTrap) are sent to the trap recipients. By default, this value is set to 0, implying that no such traps are sent. Possible values are: 0 none 1 critical 2 error 3 warning 4 informational 5 debug Refer to errShow for related information. The ACL check is as follows: there are six ACLs to restrict SNMP get/set/trap operations to hosts under a host-subnet-area. Host-subnet-area is defined by comparing nonzero IP octets. For example, an ACL of 192.168.64.0 enables access by any hosts that start with the specified octets. The connecting host is enabled to set each host-subnet-area to be read-write or read-only. The highest privilege matched out of six entries is given to the access. The ACL check is turned off when all six entries contain 0.0.0.0. The default values of all six entries are 0.0.0.0. When secure mode is enabled, the access control list feature is incorporated into the WSNMP and RSNMP security policies. Community strings can be changed on the primary FCS switch only and will propagate across the fabric. Operands none Examples To reset the SNMP agent to default values: switch:admin> agtcfgdefault ***** This command will reset the agent's configuration back to factory default ***** Current SNMP Agent Configuration Customizable MIB-II system variables: sysDescr = Fibre Channel Switch. sysLocation = End User Premise sysContact = sweng authTraps = 0 (OFF) SNMPv1 community and trap recipient configuration: Community 1: Secret C0de (rw) Trap recipient: 192.168.15.41 Trap recipient Severity level: 4 Community 2: OrigEquipMfr (rw) No trap recipient configured yet Community 3: private (rw) No trap recipient configured yet Community 4: public (ro) No trap recipient configured yet Community 5: common (ro) No trap recipient configured yet 24 Fabric OS Command Reference Manual 53-1000436-01