HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 493
portCfgISLMode, set on VE/VEX_Ports.
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 493 highlights
portCfgISLMode 2 portCfgISLMode Enables or disables ISL R_RDY mode on a port. Synopsis portcfgislmode [[slotnumber/]]portnumber, mode Description Use this command to enable or disable ISL R_RDY mode on a port. If enabling ISL R_RDY mode on a port, make sure the PID format is consistent across the entire fabric. Refer to the configure command for more information on the core PID format. This configuration can be cleared but not set on VE/VEX_Ports. ISL R_RDY mode sends an ELP with flow control mode 02. If a port is ISL R_RDY mode-enabled, it can only receive ELP with flow control mode 02; ELP with flow control mode 01 segments the fabric. This mode cannot detect any inconsistencies in fabric operating mode parameters, such as the PID format of connected ports. Before using this mode, the fabric administrator must ensure all fabric-wide parameters are consistent for every switch in the fabric. The complete list of fabric operating mode parameters is shown below: Disable Device Probing fabric.ops.mode.fcpProbeDisable Isolated Operation fabric.ops.mode.isolate Long Distance Fabric fabric.ops.mode.longDistance Suppress Class F Traffic fabric.ops.mode.noClassF Switch PID Format fabric.ops.mode.pidFormat Sequence Level Switching fabric.ops.mode.tachyonCompat Unicast-only Operation fabric.ops.mode.unicastOnly Per-frame Route Priority fabric.ops.mode.useCsCtl These parameters can be modified using configure . The following E_Port configurations are not applicable to a port configured for ISL R_RDY mode: NOTE The long distance modes L0, L1, and L2 are no longer supported in v5.3.0. • Trunk port • Long distance • VC link init If configured, these port configuration parameters are ignored during the E_Port initialization. The portCfgISLMode and portCfgLongDistance levels LE, LD, or LS only can be enabled at the same time. Such an ISL uses R_RDY mode of flow control over the long distance link. If the PID format for two ISL R_RDY mode ports are not the same, zoning will drop frames. This feature is persistent across reboots and power cycles. Use the portCfgShow command to view whether ISL R_RDY mode is enabled on a port. The portCfgISLMode and portCfgLongDistance mode both cannot be enabled at the same time; otherwise, fabric segmentation occurs. The execution of this command is subject to Admin Domain restrictions that may be in place. Fabric OS Command Reference Manual 461 53-1000436-01