HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 61

agtCfgShow 2 agtCfgShow Displays the SNMP agent configuration. Synopsis agtcfgshow Description Use this command to display the configuration of the SNMP agent in the switch. On a dual-switch chassis, there is one SNMP agent per logical switch. This command is specific to the logical switch to which you are logged in. The following information displays: sysDescr The system (switch) description. The default value is "Fibre Channel Switch". sysLocation The location of the system. The default value is "End User Premise". sysContact The contact information for the system. The default value is "Field Support". Refer to the Fabric OS MIB Reference Manual for detailed sysDescr, sysLocation, and sysContact descriptions. authTrapsEnabled When enabled, the authentication trap, authenticationFailure, is transmitted to a configured trap recipient in the event that the agent received a protocol message that is not properly authenticated. In the context of SNMPv1 and SNMPv2c, this means that a request contains a community string that is not known to the agent. The default value for this parameter is 0 (disabled). There are six communities, respective trap recipients, and trap recipient severity levels supported by the agent. The first three communities are for read-write (rw) access and the last three are for read-only (ro) access. The default value for the trap recipient of each community is '0.0.0.0'. The community string length ranges from 2 to 16 characters. The default values for the community strings are: Community 1: Secret C0de Community 2: OrigEquipMfr Community 3: private Community 4: public Community 5: common Community 6: FibreChannel For an SNMP management station to receive a trap generated by the agent, the administrator must configure a trap recipient to correspond to the IP address of the management station. In addition, the trap recipient must be able to pass the access control list (ACL) check. NOTE IP addresses or subnet masks are displayed in IPv6 or IPv4 format depending on how it was configured. The execution of this command is subject to Admin Domain restrictions that may be in place. Fabric OS Command Reference Manual 29 53-1000436-01