HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 506

2 portCfgShow ISL R_RDY Mode Displays as ON when the port has ISL R_RDY mode enabled or blank (..) when the port is ISL R_RDY mode disabled. This value is set by the portCfgISLMode command. RSCN Suppression Displays as ON when the port has RSCN suppression enabled or blank (..) when the port has RSCN suppression disabled. This value is set by the portCfg rscnsupr command. Persistent Disable Displays as ON when the port is persistently disabled. This value is set by the portCfgPersistentDisable command. Mirror Port Mode Displays as ON when the port has Mirror Port Mode enabled or blank (..) when the port has the Mirror Port Mode disabled. This value is set by the portCfg mirrorport command. NPIV capability Displays as ON when the port has N_Port ID Virtualization (NPIV) enabled or blank (..) when the port has the NPIV capability disabled. This value is set by the portCfgNPIVPort command. It is enabled by default for Condor-based ports and disabled by default for Bloom-based ports. The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: arp Displays address resolution protocol (ARP) table. fciptunnel Displays FCIP tunnels on this GbE port. Possible optional args include: all, which displays all FCIP tunnels; tunnel_id, which displays the specified FCIP tunnel; -ipsec, which displays IKE and IPSec policy information on IPSec-enabled tunnels. ipif Displays the IP interface. iproute Displays the IP route. mode Displays mode of a GbE port. slotnumber For bladed systems only, specifies the slot number of the port to display, followed by a slash (/). portnumber Specifies the port number to display, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. This operand is optional; if omitted, this command displays information for all ports. Examples To display the information for all the active FCIP tunnels on the GigE and show the current DiffServ markings being used for data connection as well as control connection: switch:admin> portcfgshow fciptunnel ge0 all Port: ge0 Tunnel ID 7 Remote IP Addr 192.168.255.17 Local IP Addr 192.168.255.107 Remote WWN Not Configured Local WWN 10:00:00:05:1e:37:00:20 Compression off Fastwrite off Tape Pipelining off Uncommitted bandwidth, minimum of 1000 Kbps (0.001000 Gbps) SACK on 474 Fabric OS Command Reference Manual 53-1000436-01