HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 508

2 portCfgSpeed portCfgSpeed Configures a port to a particular speed level. Synopsis portcfgspeed [slotnumber/]portnumber, speed_level Description Use this command to configure the speed of a port to a particular level. After this command is issued, the port is disabled and enabled so that the port comes up with the new speed setting. The configuration is saved in nonvolatile memory and is persistent across switch reboots or power cycles. This configuration cannot be set on VE/VEX_Ports. Use portShow to display the achieved speed and portCfgShow to display the user's desired speed setting. The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: slotnumber For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). portnumber Specify a port number to be configured, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. speed_level Specify the speed of a port. This operand is required. Valid values are one of the following: 0 Autosensing mode. The port automatically configures for the highest speed. 1 1-Gbit/sec mode. The port is at fixed speed of 1 Gbit/sec. 2 2-Gbit/sec mode. The port is at fixed speed of 2 Gbit/sec. 4 4-Gbit/sec mode. The port is at fixed speed of 4 Gbit/sec. Examples To set the speed of a port to 2 Gbit/sec: switch:admin> portcfgspeed 2/3, 2 See Also portCfgShow, portShow, switchCfgSpeed 476 Fabric OS Command Reference Manual 53-1000436-01