HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 165

diagShowTime 2 diagShowTime Sets or displays diagnostic show-time mode. Synopsis diagshowtime [mode | -show] Description Use this command to enable show-time mode (if the mode value is not 0) or disable the show-time mode (if the mode value is set to 0). The mode is saved in flash memory (and stays in that mode) until the next execution of diagShowTime. The mode becomes active as soon as this command is executed; it does not require a reboot to take effect. Show-time mode, when enabled, causes each test to display elapsed-time messages. It is normally used during burn-in and for test method debugging. diagshowtime is an alias of diagShowTime. You can issue this command on the FR4-18i blade in a Brocade chassis; however, the command is not supported by the Brocade platform and does not effect any other feature operations. This availability is offered to maintain consistency across a mixed-blade environment. The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: mode Specify 1 (or any nonzero value) to enable show-time mode; specify 0 to disable show-time mode. This operand is optional. -show Specify this operand to display the current mode setting. This operand is optional. If no operand is specified, the current value is displayed. Examples To enable show-time mode: switch:admin> diagshowtime Show Time mode is 0 (Disabled). switch:admin> diagshowtime 1 Config update Succeeded Show Time mode is now 1 (Enabled). See Also none Fabric OS Command Reference Manual 133 53-1000436-01