HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 339

ipAddrShow 2 ipAddrShow Displays the IP address information for a switch or control processor (CP). Synopsis ipaddrshow [-cp cp_number] ipaddrshow [-sw sw_number] ipaddrshow - slot n ipaddrshow [-eth0 -eth1 -gate] Description Use this command to display the IP addresses configured in the system. The -cp option displays the CP IP address and the -sw option displays the switch IP addresses. For switches, the command displays the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP address, and Fibre Channel subnetmask. For CPs, the command displays the Ethernet IP address, Ethernet subnetmask, host name, and gateway IP address. For chassis based systems with intelligent blades the addresses configured for each slot can be shown with the -slot option. Without any further options it will show all the addresses associated with the slot, but this can be restricted using one of the sub options. NOTE The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: -cp cp_number For dual-CP systems, this specifies the CP card number to display (0 or 1). -sw sw_number For dual-domain systems, this specifies the switch number to display (0 or 1). -slot n For chassis systems specify the slot for a blade -eth0 -eth1 -gate For a slot show only the selected ethernet interface or the gateway If no operands are specified, the command displays all the IP addresses configured in the system. For non-chassis-based switches, this command ignores all operands. Examples To display the IP address for logical switch 0: switch:admin> ipaddrshow -sw 0 Ethernet IP Address: 192.168.166.147 Ethernet Subnetmask: 255.255.255.0 Fibre Channel IP Address: 0.0.0.0 Fibre Channel Subnetmask: 0.0.0.0 See Also ipAddrSet Fabric OS Command Reference Manual 307 53-1000436-01