HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 484

2 portCfg iipaddr Specifies the interface protocol as IP and the IP address on the GbE port. Use this parameter to bring up a native IP interface for link-level diagnostics, connectivity, and characterization of SLA. Specify the IP address on this GigE port. Also use for route entries and FCIP tunnel establishment. a.b.c.d format. macaddr Specifies the MAC address, which corresponds to the IP address in the ARP table. netmask Specifies the subnet mask for the specified port or route. Uses a.b.c.d format. mtu_size Specifies the maximum transfer unit (MTU) size for the IP interface. For GE ports on a Brocade 7500 or an FR4-18i blade in a Brocade 48000, valid values are from 1500 to 2348. On an FC4-16i in a Brocade 48000 valid values are from 1500 to 8256. For v5.3.0, valid MTU size for Brocade 7500 or an FR4-18i blade are 1260 to 2348. gateway Specifies the gateway IP address for the route. metric Specifies the link metric associated with the route. Valid values are 0 to 255. The default is 0. tunnel_id Specifies the FCIP tunnel on the GbE port. Valid values are 0 through 7. local_ipaddr Specifies the IP address for the specified port. remote_ipaddr Specifies the remote-side IP address of an FCIP connection. comm_rate Specifies the committed traffic rate, in Kbit/sec, on the FCIP tunnel. Valid values are 1,544 to 1,000,000, and 0 for uncommitted. mirrorport -- Configures mirror port on the local port. A mirror port is used to output mirror traffic configured by the portMirror command. You will be prompted to confirm that the port specified will be enabled as a mirror port. Once a port is configured as a mirror port, the port can only be used as part of a mirror connection. Usage: portCfg mirrorport slot/][ge]port mode Valid modes for mirrorport are: --disable Disables the configuration. When disabled, a port cannot be a mirror port. --enable Enables the configuration. When mirrorport is enabled to a port, a mirror connection can use this port to mirror traffic. Port options for mirrorport are: slot For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). port Specify the number of the port to be configured, relative to its slot for bladed systems. Use switchShow for a list of valid ports. fastwrite-- Configure FC port for FC Fastwrite Enables or disables FC Fastwrite between two Brocade 7500 routers or two Brocade 48000 directors with an FR4-18i blades connected by Fibre Channel ISLs. The blade first should be enabled for FC fastwrite using fastWriteCfg. fastWriteCfg can also be used to list all the ports configured for FC fastwrite. Usage: portCfg faswrite [slot/][ge]port mode 452 Fabric OS Command Reference Manual 53-1000436-01