HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 747
Set all even ports' speed for auto-negotiate, set all odd ports' speed for 2
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 747 highlights
txdPath 2 Examples --slot slotnumber Specifies the slot number on which the diagnostic operates. The ports specified are relative to this slot number. The default is set to 0 and designed to operate on fixed-port-count products. -nmegs count Specify the number of million frames to send. The test progresses until the specified number of frames has been transmitted on each port. The default value is 10, so the number of frames sent are at least 10 million. -lb_mode mode Specify the loopback point for the test. By default, this command uses loopback plugs, as described earlier. However, for debug purposes, you can select other loopback modes, as follows: 1 Port loopback (loopback plugs) 2 External (SERDES) loopback 5 Internal (parallel) loopback -spd_mode mode Specify the speed for the test. This parameter is used only for Bloom and Condor ASIC-based products, where For 1 Gbit/sec-only products, this option is ignored. The exact operation of modes 5 through 8 depends upon the loopback mode selected. When speed modes 5 through 8 are used with cables, they must be connected even to odd or the test fails. Modes include: 0 Run test at 1 Gbit/sec, 2 Gbit/sec, and 4 Gbit/sec (default). 1 Set all port speeds to lock at 1 Gbit/sec 2 Set all port speeds to lock at 2 Gbit/sec. 4 Set all port speeds to lock at 4 Gbit/sec. For -lb_mode set to 0 or 1, the following speed modes are available to test the speed negotiation: 5 Set all even ports' speed for auto-negotiate, set all odd ports' speed for 1 Gbit/sec. 6 Set all even ports' speed for auto-negotiate, set all odd ports' speed for 2 Gbit/sec. 7 Set all odd ports' speed for auto-negotiate, set all even ports' speed for 1 Gbit/sec. 8 Set all odd ports' speed for auto-negotiate, set all even ports' speed for 2 Gbit/sec. For -lb_mode set to 2 or 3, the following speed modes are available to test FIFO underrun. 5,7 Set all even ports' speed for 2 Gbit/sec, set all odd ports' speed for 1 Gbit/sec. 6,8 Set all even ports' speed for 1 Gbit/sec, set all odd ports' speed for 2 Gbit/sec. -nonstop mode Specify nonstop mode. If set to a nonzero value, the test does not stop on the first error. The default value is 0. -ports itemlist Specify a list of user ports to test. By default, all of the user ports in the current switch are tested. This option can be used to restrict testing to the specified ports. To run the txdPath test: Fabric OS Command Reference Manual 715 53-1000436-01