HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 123

configDownload 2 • In the [Defined Security Policies] section, at least one member of the FCS_POLICY must be the same as a member in the previous FCS_POLICY. • In the [Active Security Policies] section, the FCS_POLICY must be exactly the same as the previous FCS_POLICY. Order of members must be maintained. • If either security policies section has a RSNMP_POLICY, then that section must have a WSNMP_POLICY. After the switch is enabled, if the switch is the primary FCS, then its security and zoning information will be propagated to all other switches in the fabric. After the switch is enabled, if the switch is a non-FCS or a backup FCS, then its security and zoning information will be overwritten by the primary FCS. Security parameters and the switch's identity cannot be changed by configDownload. Parameters such as the switch name and IP address are ignored; they are lines in the configuration file that begin with "boot". Security parameters such as secure mode setting and version stamp are ignored; they are the lines in the configuration file that begin with "sec" [License] is only accepted if the boot.mac parameter matches the licenseid (WWN) of the switch performing the download; otherwise, it is ignored. The download process is additive. The lines read from the file are added to the current switch configuration. It is therefore possible to change a single configuration variable by downloading a file with a single line. All other variables remain unchanged. The configuration parameters R_A_TOV, E_D_TOV, WAN_TOV, and MAX_HOPS are interrelated. Assigning a specific value to one or more of these parameters might change the range of allowed values that can be assigned to the other parameters. As a result, the user might not be able to set all the values within the range displayed against each parameter. This command validates the modified values of these four parameters and terminates the download operation, if the validation check fails. This is particularly important when downloading a zoning configuration. Since the new zoning information is added to the current configuration, there might not be any conflicts. If the current zoning configuration is to be replaced, the keyword "clear:" should be inserted into the configuration file immediately before the zoning lines (starting at the line "[Zoning]"). If the configuration file contains the keyword "enable:" followed by a , then that zoning configuration will be enabled in the fabric. If there is no "enable:" keyword in the configuration file or no zoning configuration by that name exists, or if enable fails for any reason (such as dangling aliases), then: The effective configuration remains as it was prior to configDownload; that is, all the "enable:" information is discarded. The Defined Configuration changes to reflect new zoning configuration. The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: -p ftp or -p scp Specifies the use of the FTP or SCP protocol. If a protocol is not specified, FTP is the default. "host" Specifies a host name or IP address in quotation marks: for example, "citadel" or "192.168.1.48". The configuration file is downloaded from this host. Fabric OS Command Reference Manual 91 53-1000436-01