HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 464

2 perfShowEEMonitor perfShowEEMonitor Displays end-to-end performance monitor information on a port. Synopsis perfshoweemonitor [slotnumber/]portnumber [interval] Description Use this command to display end-to-end monitor information on a port. Refer to perfMonitorShow for details regarding this command's output. This command requires a Brocade Advanced Performance Monitoring license. This command is not supported on virtual FC ports (VE/VEX_Port), EX_Port, M (Mirror) ports and GbE ports. The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: slotnumber For bladed systems only, this operand specifies the slot number of the port on which the monitor is to be displayed, followed by a slash (/). portnumber Specifies the number of the port on which the monitor is to be displayed, relative to its slot for bladed systems. Use switchShow for a list of valid ports. interval Specify an interval, in seconds (5 or more). Tx and Rx counts are in the unit of byte when this operand is specified. This operand is optional; if omitted, this command displays cumulative counts. Examples To display EE monitors configured on the switch port 0: switch:admin> perfshoweemonitor 0 There is 1 end-to-end monitor(s) defined on port 0. KEY SID DID OWNER_APP TX_COUNT 0 0x112233 0x223344 TELNET 0x00000000000 RX_COUNT CRC_COUNT OWNER_IP_ADDR 0x0000000000000000 0x0000000000000000 N/A The output displays the key, source and destination PID, client application used to add the monitor, client IP address where applicaiton is running followed by different counters. CLI shows IPv6 address for OWNER_IP_ADDR field. If the monitor is added using perf CLIs OWNER_IP_ADDR field will display as N/A. When a monitor is created using a telnet application, the IP address continues to display as N/A. To display the EE monitor configured on the switch port 0 using an application that passes an IPV6 address: switch:admin> perfshoweemonitor 0 There is 1 end-to-end monitor(s) defined on port 0. 432 Fabric OS Command Reference Manual 53-1000436-01