HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 229

fcrDisable 2 fcrDisable Disables the FC Routing service on a switch. This command is not supported in v5.3.0; instead use fosConfig. Synopsis fcrdisable Description Use this command to disable Fibre Channel (FC) routing on a switch. This command can be run while the switch state is "online". Instead of disabling the switch, issue this command to disable the FC Routing service only, then change the BB fabric ID using fcrConfigure. Issue fcrEnable to turn FC Routing on. To run this command, all enabled EX_Ports and VEX_Ports on the switch must be "offline", using either portCfgEXPort or portCfgVEXPort. If there are enabled EX_Ports or VEX_Ports when fcrDisable is issued, then the following message is displayed: "Please disable all EX/VEX_Ports first before running fcrDisable command." If an XPath OS switch is in the BB, it might take up to 8 minutes to complete the disable process. If you attempt to enable the feature too soon, the following message is displayed: "FC Routing service is in the process of being disable, please try again after a few minutes." If the feature is disabled already, the following message is displayed: "FC Routing service is already disabled." Use switchShow or fosConfig to display the current state of the FC Routing service Operands none Examples To disable the FC Routing service: fcr:admin> fcrdisable FC Routing service is disabled See Also fcrConfigure, fcrEnable, fosConfig, switchDisable, switchEnable, switchShow Fabric OS Command Reference Manual 197 53-1000436-01