HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 483
Creates IP routes.
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 483 highlights
portCfg 2 -r retransmissions Specifies the maximum retransmissions for the existing tunnel. retransmissions values are 1 to 16; default is 8. If tape pipelining is enabled, default value is calculated based on the mininum retransmit time to ensure that tcp connection does not timeout before the host times out. If the user changes this value, the value specified must be greater than the calculated value. -s 0|1 Disable (0) or enable (1) selective acknowledgement (SACK) on the existing tunnel. -t 0|1 Disable (0) or enable (1) tape pipelining on turned on as well). delete tunnel_id Deletes FCIP tunnel ipif -- IP interface entries. Usage: portcfg ipif [slot/][ge]port option args. Valid options and args for ipif are: create ipaddr netmask mtu_size Creates IP interfaces. delete ipaddr netmask Deletes IP interfaces. iproute -- IP route entries. Usage: portcfg iproute [slot/][ge]port option args. Valid options and args for iproute are: create ipaddr netmask gateway_router metric Creates IP routes. delete ipaddr netmask Deletes IP routes. rscnsupr -- Manages RSCN suppression on the local port. Usage: portcfg rscnsupr [slot/][ge]port [-range] mode An optional arg for rscnsupr is: -range Specifies a range of ports in the same slot to apply the configuration to. Valid modes for rscnsupr are: --disable Disables the configuration. When disabled, device changes on the port generates RSCN to another end device that is zoned with this one. By default, RSCN suppression is disabled to all ports. --enable Enables the configuration. When enabled, any device change on the port does not generate RSCN to any other end device. Optional port configuration parameters for rscnsupr are: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the ports to be configured, relative to its slot for bladed systems. For GbE ports, the ports are numbered ge0 and ge1. Use switchShow for a list of valid ports. Fabric OS Command Reference Manual 451 53-1000436-01