HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 638

2 setModem setModem Enables or disables modem dial-in to a control processor (CP). Synopsis setmodem [-e] | [-d] Description Use this command to enable or disable modem dial-in to a CP on those systems that support modem dial-in. When modem dial-in is enabled, you can log in to a CP through a modem, and a modem attached to the CP accepts the call. When modem dial-in is disabled, the modem attached to the CP does not accept the call. When entered with no operands, the command displays the currently state of modem dial-in. Modem dial-in must be through a Hayes-compatible modem attached to a CP modem serial port. If the CP is active, the modem is configured to answer an incoming call on the first ring, unless modem dial-in has been disabled with this command. If the CP is standby, the modem is configured to answer an incoming call on the seventh ring, unless modem dial-in has been disabled. In the recommended configuration, a separate modem is connected to each modem port of CP0 and CP1. These modems connect to the telephone outlet through a RJ-11 Y-adapter and standard telephone wire (see Figure ) is attached to the wall outlet. During an incoming call, both modems ring and the one connected to the active CP answers the call first. If for any reason the active modem fails to answer, the caller is logged in to the standby CP. . . . 606 Fabric OS Command Reference Manual 53-1000436-01