Netgear M5300-52G3 Web Management User Guide - Page 101

ProSafe M5300 Switch LLDP-MED Global Configuration Use the LLDP-MED Global Configuration page to specify LLDP-MED parameters that are applied to the switch. To display this page, click System  LLDP  LLDP-MED  Global Configuration. A screen similar to the following displays. To configure global LLDP-MED settings: 1. Use Fast Start Repeat Count to specify the number of LLDP PDUs that will be transmitted when the protocol is enabled. The range is from (1 to 10). Default value of fast repeat count is 3. 2. Click APPLY to update the switch with the modified setting. 3. Click CANCEL to abandon the changes. The following table describes the LLDP-MED Global Configuration fields. Field Device Class Description Specifies local device's MED Classification. There are four different kinds of devices, three of them represent the actual end points (classified as Class I Generic [IP Communication Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP Telephone etc.]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc. Configuring System Information 101