Netgear M5300-52G3 Web Management User Guide - Page 306
PIM Interface Configuration, Routing, Multicast, Interface, Configuration, Admin Mode
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 306 highlights
ProSafe M5300 Switch PIM Interface Configuration To display the PIM Interface Configuration page, click Routing Multicast PIM Interface Configuration. To configure per-interface PIM settings: 1. Select the check box associated with each interface you want to configure. Select the check box in the heading row to apply the same settings to all interfaces. 2. Use Admin Mode to set the administrative status of PIM in the router. The default is disable. 3. Use Hello Interval (secs) to enter the time in seconds between the transmission of which PIM Hello messages on this interface. The valid values are from 0 to 18000. The default value is 30. 4. Use Join/Prune Interval (secs) to enter the frequency at which PIM Join/Prune messages are transmitted on this PIM interface. The valid values are from 0 to 18000. The default value is 60. 5. Use BSR Border to set BSR border status on the selected interface. 6. Use DR Priority to enter the DR priority for the selected interface. The valid values are from 0 to 2147483647. The default value is 1. Field Protocol State IP Address Designated Router Neighbor Count Description The state of PIM in the router: either operational or non-operational. The IPv4 address of the selected PIM interface. The Designated Router on the selected PIM interface. The number of PIM neighbors on the selected interface. Routing 306