Netgear M5300-52G3 Web Management User Guide - Page 380

ProSafe M5300 Switch Telnet To display the Telnet page, click Security  Access > Telnet. Telnet Authentication List This page allows you to select the login and enable authentication list available. The login list specifies the authentication method(s) you want used to validate switch or port access for the users associated with the list. The enable list specifies the authentication method(s) you want used to validate privileged EXEC access for the users associated with the list. These list can be created by Authentication List page under Management Security. 1. Use Login Authentication List to specify which authentication list to use when you login through telnet. The default value is networkList. 2. Use Enable Authentication List to specify which authentication list you are using when going into the privileged EXEC mode. The default value is enableList. Inbound Telnet Configuration This page regulates new telnet sessions. If Allow New Telnet Sessions are enabled, new inbound telnet sessions can be established until there are no more sessions available. If Allow New Telnet Sessions are disabled, no new inbound telnet sessions are established. An established session remains active until the session is ended or an abnormal network error ends the session. 1. Use Allow New Telnet Sessions to specify whether the new Inbound Telnet session is Enabled or Disabled. Default value is Enabled. 2. Use Session Timeout to specify how many minutes of inactivity should occur on a telnet session before the session is logged off. You may enter any number from 1 to 160. The factory default is 5. 3. Use Maximum Number of Sessions to select how many simultaneous telnet sessions will be allowed. The maximum is 5, which is also the factory default. 4. Current Number of Sessions - Displays the number of current sessions. Managing Device Security 380