Netgear M5300-52G3 Web Management User Guide - Page 87

ProSafe M5300 Switch SNMP From SNMP link under the System tab, you can configure SNMP settings for SNMP V1/V2 and SNMPv3. From the SNMP link, you can access the following pages: • SNMPV1/V2 on page 87 • SNMP V3 User Configuration on page 92 SNMPV1/V2 The pages under the SNMPV1/V2 menu allow you to configure SNMP community information, traps, and trap flags. From the SNMP V1/V2 link, you can access the following pages: • Community Configuration on page 87 • Trap Configuration on page 89 • Trap Flags on page 90 • Supported MIBs on page 91 Community Configuration By default, two SNMP Communities exist: • Private, with Read/Write privileges and status set to Enable. • Public, with Read Only privileges and status set to Enable. These are well-known communities. Use this page to change the defaults or to add other communities. Only the communities that you define using this page will have access to the switch using the SNMPv1 and SNMPv2c protocols. Only those communities with read/write level access can be used to change the configuration using SNMP. Use this page when you are using the SNMPv1 and SNMPv2c protocol. If you want to use SNMP v3 you should use the User Accounts menu. To display this page, click System  SNMP  SNMP V1/V2  Community Configuration. A screen similar to the following displays. Configuring System Information 87