Netgear M5300-52G3 Web Management User Guide - Page 202

ProSafe M5300 Switch IPv6 Global Configuration Use the Global Configuration page to enable IPv6 forwarding on the router and to enable the forwarding of IPv6 unicast datagrams. To display the IPv6 Global Configuration page, click Routing IPv6 Basic  Global Configuration. To configure global IPv6 routing: 1. Use IPv6 Unicast Routing to globally enable or disable IPv6 unicast routing on the entity. 2. Use the Hop Limit option to define the unicast hop count used in IPv6 packets originated by the node. The value is also included in router advertisements. Valid values for are 1-64 inclusive. The default "not configured" means that a value of zero is sent in router advertisements and a value of 64 is sent in packets originated by the node. Note that this is not the same as configuring a value of 64. 3. Use ICMPv6 Rate Limit Error Interval to control the ICMPv6 error packets by specifying the number of ICMP error packets that are allowed per burst interval. By Default Rate limit is 100 packets/sec i.e., burst interval is 1000 msec. To disable ICMP rate limiting set this field to '0'. Valid Rate Interval must be in the range 0 to 2147483647. 4. Use ICMPv6 Rate Limit Burst Size to control the ICMP error packets by specifying the number of ICMP error packets that are allowed per burst interval. Default burst size is 100 packets. When burst interval is 0 then configuring this field is not a valid operation. Valid Burst Size must be in the range 1 to 200. 5. Click APPLY to update the switch with the changes. 6. Click CANCEL to abandon the changes. Routing 202