Netgear M5300-52G3 Web Management User Guide - Page 193
IP, Basic, Routing, IP Configuration, Routing Mode, ICMP Echo Replies, ICMP Redirects
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
ProSafe M5300 Switch IP The IP folder contains links to the following web pages that configure and display IP routing data: • Basic on page 193 • Advanced on page 197 Basic From the Basic link, you can access the following pages: • IP Configuration on page 193 • Statistics on page 194 IP Configuration Use this menu to configure routing parameters for the switch, as opposed to an interface. To display the IP Configuration page, click Routing IP Basic IP Configuration. To configure global IP routing: 1. Use Routing Mode to select enable or disable. You must enable routing for the switch before you can route through any of the interfaces. The default value is disable. 2. Use ICMP Echo Replies to select enable or disable. If it is enable then only the router can send ECHO replies. By default ICMP Echo Replies are sent for echo requests. 3. Use ICMP Redirects to select enable or disable. If it is enabled globally and on interface level then only the router can send ICMP Redirects. 4. Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number of ICMP error packets that are allowed per burst interval. By default, Rate limit is 100 packets/sec i.e., burst interval is 1000 msec. To disable ICMP Rate limiting, set this field to '0'. Valid Rate Interval must be in the range 0 to 2147483647. Routing 193