Netgear M5300-52G3 Web Management User Guide - Page 455

ProSafe M5300 Switch VLAN Binding Table Use this page to bind ACLs to VLANs on the switch rather than to ports. At the bottom of the page, the table displays any currently-configured ACLs for the selected VLAN. You can also bind an ACL to a port To display the VLAN Binding Table, click Security  ACL> Advanced  VLAN Binding Table. The following table describes the information displayed in the ACL VLAN Binding Table. 1. In the VLAN ID field, specify the VLAN to which an IP will be bound. 2. Use Direction to specify the packet filtering direction for ACL. Valid directions are Inbound. 3. Use Sequence Number to specify the order of the specified ACL relative to other ACLs assigned to selected interface and direction. A lower number indicates higher precedence order. If a sequence number is already in use for this VLAN and direction, the specified access list replaces the currently attached access list using that sequence number. If the sequence number is not specified by the user (i.e. the value is 0), a sequence number that is one greater than the highest sequence number currently in use for this VLAN and direction will be used. Valid range is (1 to 4294967295). 4. Use ACL Type to specify the type of ACL. Valid ACL Types include IP ACL, MAC ACL, and IPv6 ACL.. 5. Use ACL ID to display all the ACLs configured, depending on the ACL Type selected. 6. Click APPLY to add the configured ACL-to-VLAN binding. 7. To delete a VLAN ACL-to-interface binding, select the check box next to the VLAN and click DELETE. Managing Device Security 455