Netgear M5300-52G3 Web Management User Guide - Page 232
OSPF, Basic, Routing, Configuration, Router ID, Admin Mode, APPLY, CANCEL
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
ProSafe M5300 Switch OSPF Note: OSPF is a licensed feature and is available only on switches that have an active license installed. From the OSPF link, you can access the following pages: • Basic on page 232 • Advanced on page 233 Basic From the Basic link, you can access the following pages: • OSPF Configuration (Basic) on page 232 OSPF Configuration (Basic) Use the OSPF Configuration page to enable OSPF on a router and to configure the related OSPF settings. To display the OSPF Configuration page, click Routing OSPF Basic OSPF Configuration. To configure the administrative mode of OSPF on the switch: 1. Use Router ID to specify a 32-bit integer in dotted decimal format that uniquely identifies the router within the autonomous system (AS). To change the Router ID you must first disable OSPF. After you set the new Router ID, you must re-enable OSPF to have the change take effect. The default value is 0.0.0.0, although this is not a valid Router ID. 2. Use Admin Mode to select enable or disable. If you select enable, OSPF will be activated for the switch. The default value is disable. You must configure a Router ID before OSPF can become operational; see step 1 or by issuing the CLI command: (Config-router)#router-id. 3. Click APPLY to update the switch with the changes. 4. Click CANCEL to abandon the changes. Routing 232