Netgear M5300-52G3 Web Management User Guide - Page 74
Stack Port Configuration, System, Stacking, Advanced, Stack
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
ProSafe M5300 Switch The following table describes the Basic Stack Status fields. Field Unit ID Switch Description Serial Number Uptime Preconfigured Model Identifier Plugged-in Model Identifier Detected Code Version Detected Code Version in Flash SFS Last Attempt Status Description The unit ID of the specific switch. The description for the unit can be configured by the user. The unique box serial number for this switch. The displays the relative time since the last reboot of the switch. This field displays the model type assigned by the device manufacturer to identify the device. This field displays the model type assigned by the device manufacturer to identify the plugged-in device. This field indicates the detected version of code on this unit. The displays the Release number and version number of the code stored in flash. This displays the status of last tried stack firmware synchronisation. "None" is the default value if SFS has not been tried. Stack Port Configuration By default, the stack ports on each switch are configured for stacking. However, you can use these ports as standard Ethernet ports. Use the Stack Port configuration page to configure the mode of the stack ports and to view information about the ports. To display the Stack Port Configuration page, click System Stacking Advanced Stack Port Configuration. A screen similar to the following is displayed (the page is shown in two parts). Configuring System Information 74