Netgear M5300-52G3 Web Management User Guide - Page 230

ProSafe M5300 Switch Route Redistribution Use the RIP Route Redistribution page to configure which routes are redistributed to other routers using RIP. The allowable values for each fields are displayed next to the field. If any invalid values are entered, an alert message is displayed with the list of all the valid values. To display the Route Redistribution page, click Routing RIP Advanced  Route Redistribution. RIP Route Redistribution Configuration This screen can be used to configure the RIP Route Redistribution parameters. The allowable values for each fields are displayed next to the field. If any invalid values are entered, an alert message will be displayed with the list of all the valid values. 1. The Source select box is a dynamic selector and is populated by only those Source Routes that have already been configured for redistribute by RIP. Use Source to configure another Source Route from among the Available Source Routes. The valid values are: • Static • Connected • OSPF 2. Use Redistribute Mode to enable or disable RIP redistribute mode. The default value is disable. 3. Use Metric to specify the Metric of redistributed routes for the given Source Route. 4. Use Distribute List to set the Access List that filters the routes to be redistributed by the destination protocol. Only permitted routes are redistributed. If this command refers to a non-existent access list, all routes are permitted. The valid values for Access List IDs are 1 to 199. When used for route filtering, the only fields in an access list that get used are: • Source IP Address and netmask • Destination IP Address and netmask • Action (permit or deny) All other fields (source and destination port, precedence, ToS, etc.) are ignored. 5. Click APPLY to update the switch with the changes. 6. Click CANCEL to abandon the changes. Routing 230