Oki MB471 Users Manual Advanced - Page 86

Admin Setup, Other, Settings, Block Junk Fax, Mode2, Sets the mode of Block Junk Fax.

Get Oki MB471 PDF manuals and user guides View all Oki MB471 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 86 highlights

List of the Device Setting Menu Items Item Factory Default Description Other Settings Fax Setting Redial Tries Redial Interval Block Junk Fax Setting Registered List Register/Edit Delete Ring Response Dialling Pause Duration Rx Reduc. Rate Reduc. Margin ECM Mode PreFix Received Time Stamp Print Check Message Service Bit Country Code A/R Full Print Tone For Echo (For Transmission) Tone For Echo (For Reception) 2 times Sets the number of redial attempts. Available range: 0 to 9 times. 1 minute Sets the time between redial attempts. Available range: 1 to 5 minutes. OFF Sets the mode of Block Junk Fax. (No Entry) Register/Edit addresses for Block Junk Fax. Display condition: [Admin Setup]>[Other Settings]>[Block Junk Fax]>[Setting] is set to [Mode2]. (Nothing: con- Delete addresses for Block Junk Fax. Dis- nect Item cell play condition: [Admin Setup]>[Other and Factory Settings]>[Block Junk Fax]>[Setting] is default cell) set to [Mode2]. 1 ring Sets the number of rings required before receiving an incoming fax. 2 seconds Sets the dial pause time. Available range: 0 to 10 seconds. Auto Sets the reception reduction rate. 24 mm or 3.9 inch Sets the threshold level of reception reduction. Available range: 0 to 100 mm (0 to 3.9 inches). ON Sets whether to use the error correction mode. NULL Sets the dialing prefix. Maximum 40 digits. OFF Sets whether the time stamp is printed on incoming faxes. ON Sets whether the error content is reported when a transmission error occurs. OFF If set OFF, some menu items are not dis- played on the panel. International Sets the country code. or U.S.A or Australia(Sin- gapore) ON Sets whether to print the list of the com- munication results automatically after every 50 communications. Disable It only shows, when ServiceBit = ON. Disable It only shows, when ServiceBit = ON. H/Modem Rate(For Tx) H/Modem Rate(For Rx) Attenuator 33.6 Kbps Sets the default value of the modem transmission speed while the machine is sending a fax. 33.6 Kbps Sets the default value of the modem transmission speed while the machine is receiving a fax. 10 dB, Range : Enter Attenuator.It only shows, when Ser- 0-15 dB vice Bit = ON. - 86 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
List of the Device Setting Menu Items
- 86 -
Other
Settings
Redial Tries
2 times
Sets the number of redial attempts.
Available range: 0 to 9 times.
Redial Interval
1 minute
Sets the time between redial attempts.
Available range: 1 to 5 minutes.
Block Junk Fax
Setting
OFF
Sets the mode of Block Junk Fax.
Registered
List
Register/Edit
(No Entry)
Register/Edit addresses for Block Junk Fax.
Display condition: [
Admin Setup
]>[
Other
Settings
]>[
Block Junk Fax
]>[
Setting
] is
set to [
Mode2
].
Delete
(Nothing: con-
nect Item cell
and Factory
default cell)
Delete addresses for Block Junk Fax. Dis-
play condition: [
Admin Setup
]>[
Other
Settings
]>[Block Junk Fax]>[
Setting
] is
set to [
Mode2
].
Ring Response
1 ring
Sets the number of rings required before
receiving an incoming fax.
Dialling Pause Duration
2 seconds
Sets the dial pause time.
Available range: 0 to 10 seconds.
Rx Reduc. Rate
Auto
Sets the reception reduction rate.
Reduc. Margin
24 mm or 3.9
inch
Sets the threshold level of reception
reduction.
Available range: 0 to 100 mm
(0 to 3.9 inches).
ECM Mode
ON
Sets whether to use the error correction
mode.
PreFix
NULL
Sets the dialing prefix. Maximum 40 dig-
its.
Received Time Stamp
OFF
Sets whether the time stamp is printed on
incoming faxes.
Print Check Message
ON
Sets whether the error content is reported
when a transmission error occurs.
Fax
Setting
Service Bit
OFF
If set OFF, some menu items are not dis-
played on the panel.
Country Code
International
or U.S.A or
Australia(Sin-
gapore)
Sets the country code.
A/R Full Print
ON
Sets whether to print the list of the com-
munication results automatically after
every 50 communications.
Tone For Echo (For Transmission)
Disable
It only shows, when ServiceBit = ON.
Tone For Echo (For Reception)
Disable
It only shows, when ServiceBit = ON.
H/Modem Rate(For Tx)
33.6 Kbps
Sets the default value of the modem
transmission speed while the machine is
sending a fax.
H/Modem Rate(For Rx)
33.6 Kbps
Sets the default value of the modem
transmission speed while the machine is
receiving a fax.
Attenuator
10 dB, Range :
0-15 dB
Enter Attenuator.It only shows, when Ser-
vice Bit = ON.
Item
Factory
Default
Description