Dell PowerConnect 5324 Command Line Interface Guide - Page 125
back-pressure - console cable
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Default Configuration Automatic crossover is enabled Command Mode Interface Configuration (Ethernet) mode User Guidelines • Mdix Auto: All possibilities to connect a PC with cross OR normal cables are supported and are automatically detected. • Mdix ON: It is possible to connect to a PC only with a normal cable and to connect to another switch ONLY with a cross cable. • If MDIX is set to "no mdix", the device works opposite from the "MDIX On" behavior. With this setting you can only use either an ethernet standard cross-over cable to connect to a PC, or an ethernet standard cable to connect to another switch. Example In the following example, automatic crossover is enabled on g5. Console(config)# interface ethernet g5 Console(config-if)# mdix auto back-pressure The back-pressure Interface Configuration mode command enables Back Pressure on a given interface. To disable Back Pressure, use the no form of this command. Syntax back-pressure no back-pressure Default Configuration Back Pressure is disabled. Command Mode Interface Configuration (Ethernet, port-channel) mode User Guidelines • Back Pressure will operate only if duplex mode is set to half. Ethernet Configuration Commands 125