Dell PowerConnect 5324 Command Line Interface Guide - Page 142
garp timer
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
www.dell.com | support.dell.com Command Mode Interface Configuration (Ethernet, port-channel) mode User Guidelines • An access port would not dynamically join a VLAN because it is always a member in only one VLAN. • Membership in an untagged VLAN would be propagated in a same way as a tagged VLAN. i.e. in such a case it's the administrator's responsibility to set the PVID to be the untagged VLAN VID. Example The following example enables GVRP on ethernet g8. Console (config)# interface ethernet g8 Console (config-if)# gvrp enable garp timer The garp timer Interface Configuration mode command adjusts the GARP application join, leave, and leaveall GARP timer values. To reset the timer to default values, use the no form of this command. Syntax garp timer {join | leave | leaveall} timer_value no garp timer • join-Indicates the time in milliseconds that PDUs are transmitted. (Range: 10-2147483640) • leave-Indicates the amount of time in milliseconds that the device waits before leaving its GARP state. The Leave Time is activated by a Leave All Time message sent/received, and cancelled by the Join message. (Range: 10-2147483640) • leaveall-Used to confirm the port within the VLAN. The time in milliseconds between messages sent. (Range: 10-2147483640) • timer_value-Timer values in milliseconds. Default Configuration The default timer values are as follows: • Join timer-200 milliseconds • Leave timer-600 milliseconds • Leavall timer-10000 milliseconds 142 GVRP Commands