Dell PowerConnect 5324 Command Line Interface Guide - Page 203
port channel load balance, show interfaces port-channel, interface ethernet, channel-group 1 mode
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Example The following example shows how port g5 is configured to port-channel number 1 without LACP. Console (config)# interface ethernet g5 Console (config-if)# channel-group 1 mode on port channel load balance Use the port-channel load-balance global configuration command to configure the load balancing policy of the port channeling. Use the no form of this command to reset to default. Syntax port-channel load-balance {layer-2 | layer-2-3 | layer-2-3-4} no port-channel load-balance • layer-2 - Port channel load balancing is based on layer 2 parameters. • layer-2-3 - Port channel load balancing is based on layer 2 and layer 3 parameters. • layer-2-3-4 - Port channel load balancing is based on layer 2, layer 3 and layer 4 parameters. Default Configuration Layer 2 Command Modes Global Configuration User Guidelines • In L2+L3+L4 load balancing policy, fragmented packets might be reordered. Example The following example configures the load balancing policy of the port channeling on layer 2. Console (config) # port-channel load-balance layer-2 show interfaces port-channel Use the show interfaces port-channel global configuration command to show Port channel information. Syntax show interfaces port-channel [port-channel-number] Port Channel Commands 203