Dell PowerConnect 5324 Command Line Interface Guide - Page 377

dot1x max-req The dot1x max-req Interface Configuration mode command sets the maximum number of times that the switch sends an Extensible Authentication Protocol (EAP) - request/identity frame (assuming that no response is received) to the client, before restarting the authentication process. Use the no form of this command to return to the default setting. Syntax dot1x max-req count no dot1x max-req • count-Number of times that the switch sends an EAP - request/identity frame before restarting the authentication process. (Range: 1 - 10) Default Configuration 2 Command Mode Interface configuration (Ethernet) mode User Guidelines • You should change the default value of this command only to adjust for unusual circumstances, such as unreliable links or specific behavioral problems with certain clients and authentication servers. Examples The following example sets the number of times that the switch sends an EAP - request/identity frame, to 6 . Console (config)# interface ethernet g8 Console (config-if)# dot1x max-req 6 dot1x timeout supp-timeout The dot1x timeout supp-timeout Interface Configuration mode command sets the time for the retransmission of an Extensible Authentication Protocol (EAP)-request frame to the client. Use the no form of this command to return to the default setting. Syntax dot1x timeout supp-timeout seconds no dot1x timeout supp-timeout • seconds-Time in seconds that the switch should wait for a response to an EAP-request frame from the client before resending the request. (Range: 1 - 65535 seconds) 802.1x Commands 377