Dell PowerConnect 5324 Command Line Interface Guide - Page 152
ip igmp snooping leave-time-out
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
www.dell.com | support.dell.com User Guidelines • There are no user guidelines for this command. Example The following example configures the mrouter timeout to 200 seconds. Console (config)# interface vlan 2 Console (config-if)# ip igmp snooping mrouter-time-out 200 ip igmp snooping leave-time-out The ip igmp snooping leave-time-out VLAN Interface Configuration mode command configures the leave-time-out. If an IGMP report for a multicast group is not received within the leave-timeout period after an IGMP leave was received from a specific port, the current port is deleted from the member list of that multicast group. To configure the default leave-time-out, use the no form of this command. Syntax ip igmp snooping leave-time-out {time-out | immediate-leave} no ip igmp snooping leave-time-out • time-out-leave-time-out in seconds. (Range: 0 - 2147483647) • immediate-leave-Specifies that the port should be immediately removed from the members list after receiving IGMP Leave. Default Configuration The default leave-time-out configuration is 10 seconds. Command Mode Interface Configuration (VLAN) mode User Guidelines • The leave timeout should be set greater than the maximum time that a host is allowed to respond to an IGMP Query. • Use immediate leave only where there is only one host connected to a port. Example The following example configures the host leave-time-out to 60 seconds. Console (config)# interface vlan 2 Console (config-if)# ip igmp snooping leave-time-out 60 152 IGMP Snooping Commands