Dell PowerConnect 5324 Command Line Interface Guide - Page 78

www.dell.com | support.dell.com Console (config)# interface vlan 2 Console (config-vlan)# bridge address 3a:a2:64:b3:a2:45 ethernet g8 permanent bridge multicast filtering The bridge multicast filtering Global Configuration mode command enables filtering of multicast addresses. To disable filtering of multicast addresses, use the no form of the bridge multicast filtering command. Syntax bridge multicast filtering no bridge multicast filtering Default Configuration Disabled. All multicast addresses are flooded to all ports. Command Mode Global Configuration mode User Guidelines • If devices exist on the VLAN, do not change the unregistered multicast addresses state to drop on the devices ports. • If multicast routers exist on the VLAN and IGMP-snooping is not enabled, the bridge multicast forward-all command should be used to enable forwarding all multicast packets to the multicast routers. Example In this example, bridge multicast filtering is enabled. Console (config)# bridge multicast filtering bridge multicast address The bridge multicast address Interface Configuration mode command registers MAC-layer multicast addresses to the bridge table, and adds static ports to the group. To unregister the MAC address, use the no form of the bridge multicast address command. Syntax bridge multicast address {mac-multicast-address | ip-multicast-address} 78 Address Table Commands