Dell PowerConnect 5324 Command Line Interface Guide - Page 266
spanning-tree cost
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 266 highlights
www.dell.com | support.dell.com Command Modes Interface Configuration (Ethernet, port-channel) mode User Guidelines • When STP is disabled, the device will not forward STP BPDU's based on the Forward BPDU's setting. Example The following example disables spanning-tree on g5. Console (config)# interface ethernet g5 Console (config-if)# spanning-tree disable spanning-tree cost The spanning-tree cost Interface Configuration mode command configures the spanning-tree path cost for a port. To reset the default port path cost, use the no form of this command. Syntax spanning-tree cost cost no spanning-tree cost • cost-The port path cost (Range: 1 - 200,000,000) Default Configuration For the default short pathcost method, the cost values are: port channel - 4; 1000 mbps - 4; 100 mbps - 19; 10 mbps - 100. Command Modes Interface Configuration (Ethernet, port-channel) mode User Guidelines • The method used (long or short) is set by using the spanning-tree pathcost method command. Example The following example configures the spanning-tree cost on g5 to 35000. Console(config)# interface ethernet g5 Console(config-if)# spanning-tree cost 35000 266 Spanning-Tree Commands