Dell PowerConnect 5324 Command Line Interface Guide - Page 136

www.dell.com | support.dell.com Symbol Errors Received Pause Frames Transmitted Pause Frames For an interface operating at 100 Mb/s, the number of times there was an invalid data symbol when a valid carrier was present.For an interface operating in half-duplex mode at 1000 Mb/s, the number of times the receiving media is non-idle (a carrier event) for a period of time equal to or greater than slotTime, and during which there was at least one occurrence of an event that causes the PHY to indicate 'Data reception error' or 'carrier extend error' on the GMII.For an interface operating in full-duplex mode at 1000 Mb/s, the number of times the receiving media is non-idle (a carrier event) for a period of time equal to or greater than minFrameSize, and during which there was at least one occurrence of an event that causes the PHY to indicate 'Data reception error' on the GMII.For an interface operating at 10 Gb/s, the number of times the receiving media is non-idle (a carrier event) for a period of time equal to or greater than minFrameSize, and during which there was at least one occurrence of an event that causes the PHY to indicate 'Receive Error' on the XGMII. Counted MAC Control frames received with an opcode indicating the PAUSE operation. Counted MAC Control frames transmitted on this interface with an opcode indicating the PAUSE operation. show ports jumbo-frame The show ports jumbo-frame User EXEC mode command displays the jumbo frames configuration. Syntax show ports jumbo-frame Default Configuration This command has no default configuration. Command Modes User EXEC mode User Guidelines • There are no user guidelines for this command. 136 Ethernet Configuration Commands