Dell PowerConnect 5324 Command Line Interface Guide - Page 158
ip address dhcp
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
www.dell.com | support.dell.com • prefix-length-The number of bits that comprise the IP address prefix. The prefix length must be preceded by a forward slash (/). (Range: 8 -30) Default Configuration No IP address is defined for interfaces. Command Mode Interface configuration (Ethernet, VLAN, port-channel) User Guidelines • An IP address cannot be configured for a range of interfaces (range context). Example The following example configures VLAN 1 with the IP address 131.108.1.27 and subnet mask 255.255.255.0. Console (config)# interface vlan 1 Console (config-if)# ip address 131.108.1.27 255.255.255.0 ip address dhcp The ip address dhcp Interface Configuration mode command acquires an IP address on an interface from the Dynamic Host Configuration Protocol (DHCP) server. To deconfigure any acquired address, use the no form of this command. The no ip address dhcp command deconfigures any IP address that was acquired, thus sending a DHCPRELEASE message. Syntax ip address dhcp [hostname host-name] no ip address dhcp • hostname-Specifies the host name.(Range: 1 - 20 characters) • host-name-DHCP host name. This name need not be the same as the host name entered in global configuration mode. Default Configuration This command has no default configuration. Command Mode Interface configuration (Ethernet, VLAN, port-channel) 158 IP Addressing Commands