Brother International HL 1850 Service Manual - Page 159

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY 3.26 Exit Roller Unit NOTE: Be sure to disconnect all the connectors on the fan relay PCB before removing the exit roller unit. (1) Remove the two shoulder screws to remove the exit roller unit from the printer. Shoulder screws Exit roller unit Fig. 4-95 (2) Remove the two bind B M4x10 Taptite screws to remove the exit roller holder from the exit roller unit. (3) Lift up and remove the pinch roller ASSY from the exit roller unit, and then remove the pinch roller spring from the pinch roller ASSY. (4) Remove the cup B M3x8 Taptite screw to remove the rear cover sensor PCB ASSY from the unit. Exit roller holder Taptite, bind B M4x10 Pinch roller ASSY Taptite, cup B M3x8 Rear cover sensor PCB ASSY Pinch roller spring Adhesive tape Pinch roller ASSY Adhesive tape Exit roller ASSY ZLh Exit roller unit 4-64