HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 149
loopback-detection global enable, Views, Predefined user roles, Parameters, Usage guidelines, Example
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Views System view Predefined user roles network-admin Parameters shutdown: Enables the shutdown mode. If a loop is detected, the device generates a log and shuts down the port. Usage guidelines Use this command to configure the loop protection action globally. To configure the loop protection action on a specific port, use the loopback-detection action command in interface view. The global configuration applies to all ports. The per-port configuration applies to the individual ports. The per-port configuration takes precedence over the global configuration. Example # Set the global loop protection action to shutdown. system-view [System] loopback-detection global action shutdown Related commands • display loopback-detection • loopback-detection action loopback-detection global enable Use loopback-detection global enable to enable loop detection globally. Use undo loopback-detection global enable to disable loop detection globally. Syntax loopback-detection global enable vlan { vlan-list | all } undo loopback-detection global enable vlan { vlan-list | all } Default The loop detection function is globally disabled. Views System view Predefined user roles network-admin Parameters vlan-list: Specifies a VLAN list, in the format of { vlan-id [ to vlan-id ] }&, where vlan-id represents the VLAN ID in the range of 1 to 4094, and & indicates that you can specify up to 10 vlan-id [ to vlan-id ] parameters. all: Specifies all existing VLANs. 142