HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 99
port-isolate group
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Syntax port-isolate enable group group-number undo port-isolate enable Default No ports are assigned to an isolation group. Views Ethernet interface view, aggregate interface view Predefined user roles network-admin Parameters group group-number: Specifies an isolation group by its number in the range of 1 to 8. Usage guidelines The configuration in Ethernet interface view applies only to the interface. The configuration in aggregate interface view applies to the aggregate interface and its aggregation member ports. If the device fails to apply the configuration to the aggregate interface, it does not assign any aggregation member port to the isolation group. If the failure occurs on an aggregation member port, the device skips the port and continues to assign other aggregation member ports to the isolation group. You cannot assign the member ports of a service loopback group to an isolation group, and vice versa. Make sure the isolation group specified in the command already exists. Examples # Assign ports Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 to isolation group 2. system-view [Sysname] interface ten-gigabitethernet 1/1/5 [Sysname-Ten-GigabitEthernet1/1/5 port-isolate enable group 2 [Sysname-Ten-GigabitEthernet1/1/5] quit [Sysname] interface ten-gigabitethernet 1/1/6 [Sysname-Ten-GigabitEthernet1/1/6] port-isolate enable group 2 Related commands display port-isolate group port-isolate group Use port-isolate group to create an isolation group. Use undo port-isolate group to delete isolation groups. Syntax port-isolate group group-number undo port-isolate group { group-number | all } Default No isolation group exists. 92