HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 173
qinq transparent-vlan
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 173 highlights
Syntax qinq ethernet-type service-tag hex-value undo qinq ethernet-type service-tag Default The SVLAN TPID is 0x8100. Views Ethernet interface view, aggregate interface view Predefined user roles network-admin Parameters hex-value: Sets a hexadecimal TPID value in the range of 0x0001 to 0xFFFF, excluding the common protocol type values listed in Table 35. Usage guidelines TPID identifies a frame as an 802.1Q tagged frame. A service provider-side port uses the SVLAN TPID to re-mark the TPID in outgoing frames' SVLAN tags, in addition to matching incoming tagged frames. Examples # Set the SVLAN TPID to 0x9100 on FortyGigE 1/1/1. system-view [Sysname] interface fortygige 1/1/1 [Sysname-FortyGigE1/1/1] qinq ethernet-type service-tag 9100 qinq transparent-vlan Use qinq transparent-vlan to configure transparent transmission for a list of VLANs on a QinQ-enabled port, so the port transmits frames from the specified VLANs without performing QinQ tagging. Use undo qinq transparent-vlan to remove the transparent transmission configuration for a list of VLANs on a port. Syntax qinq transparent-vlan vlan-list undo qinq transparent-vlan { vlan-list | all } Default Transparent transmission is not configured for any VLAN on a port. Views Ethernet interface view, aggregate interface view Predefined user roles network-admin 166