HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 88
link-aggregation ignore vlan
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
The load sharing criteria that you configure will overwrite the previous criteria. If unsupported load sharing criteria are configured, an error prompt will appear. In system view, the switch supports the following load sharing criteria and combinations: • Load sharing criteria automatically determined based on the packet type • Source IP address • Destination IP address • Source MAC address • Destination MAC address • Source IP address and destination IP address • Source IP address and source port • Destination IP address and destination port • Source IP address, source port, destination IP address, and destination port • Any combination of incoming port, source MAC address, and destination MAC address Examples # Configure the destination MAC address as the global link-aggregation load sharing criterion. system-view [Sysname] link-aggregation global load-sharing mode destination-mac Related commands link-aggregation load-sharing mode link-aggregation ignore vlan Use link-aggregation ignore vlan to configure a Layer 2 aggregate interface to ignore the specified VLANs. Use undo link-aggregation ignore vlan to restore the default. Syntax link-aggregation ignore vlan vlan-id-list undo link-aggregation ignore vlan vlan-id-list Default A Layer 2 aggregate interface does not ignore any VLANs. Views Layer 2 aggregate interface view Predefined user roles network-admin Parameters vlan-id-list: Specifies a list of VLANs to be ignored in the format of vlan-id-list = { vlan-id1 [ to vlan-id2 ] }&, where vlan-id1 and vlan-id2 are both in the range of 1 to 4094, vlan-id2 cannot be smaller than vlan-id1, and & indicates that you can specify up to 10 vlan-id1 [ to vlan-id2 ] parameters. 81