HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 38
storm-constrain interval, Default, Views, Predefined user roles, Examples, Syntax, Parameters
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Default An interface sends out traps when monitored traffic exceeds the upper threshold or falls below the lower threshold. Views Ethernet interface view Predefined user roles network-admin Examples # Enable Ten-GigabitEthernet 1/1/5 to send traps when it detects storm control threshold events. system-view [Sysname] interface ten-gigabitethernet 1/1/5 [Sysname-Ten-GigabitEthernet1/1/5] storm-constrain enable trap storm-constrain interval Use storm-constrain interval to set the traffic polling interval of the storm control module. Use undo storm-constrain interval to restore the default. Syntax storm-constrain interval seconds undo storm-constrain interval Default The storm control module polls traffic statistics every 10 seconds. Views System view Predefined user roles network-admin Parameters seconds: Sets the traffic polling interval of the storm control module, in the range of 1 to 300 seconds. Usage guidelines The interval set by the storm-constrain interval command is specific to storm control. To set the statistics polling interval of an interface, use the flow-interval command. For network stability, use the default or a higher polling interval. Examples # Set the traffic statistics polling interval of the storm control module to 60 seconds. system-view [Sysname] storm-constrain interval 60 Related commands • storm-constrain 31