HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 197
lldp admin-status, Syntax, Default
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
Location Identification TLV NO NO Extended Power via MDI TLV YES YES Inventory TLV YES YES Table 41 Command output Field LLDP tlv-config of port 1 NAME STATUS DEFAULT Basic optional TLV IEEE 802.1 extended TLV IEEE 802.3 extended TLV LLDP-MED extend TLV Description Advertisable optional TLVs of port 1. TLV type. Indicates whether a specific type of TLV is sent through a port. Indicates whether a specific type of TLV is sent through a port by default. Basic TLVs: • Port description TLV. • System name TLV. • System description TLV. • System capabilities TLV. • Management address TLV. IEEE 802.1 organizationally specific TLVs: • Port VLAN ID TLV. • Port and protocol VLAN ID TLV. • VLAN name TLV. • DCBX TLV. IEEE 802.3 organizationally specific TLVs: • MAC-Physic TLV. • Power via MDI TLV. • Link aggregation TLV. • Maximum frame size TLV. LLDP-MED TLVs: • Capabilities TLV. • Network Policy TLV. • Extended Power-via-MDI TLV. • Location Identification TLV. • Inventory TLV. lldp admin-status Use lldp admin-status to specify the LLDP operating mode. Use undo lldp admin-status to restore the default LLDP operating mode. Syntax lldp admin-status { disable | rx | tx | txrx } undo lldp admin-status Default The LLDP operating mode is TxRx. 190