HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 53

• Do not assign an aggregate interface and any of its member interfaces to an interface range at the same time. Some commands, after being executed on both an aggregate interface and its member interfaces, can break up the aggregation. • No limit is set on the maximum number of interfaces in an interface range. The more interfaces in an interface range, the longer the command execution time. • The maximum number of interface range names is only limited by the system resources. To guarantee bulk interface configuration performance, HP recommends configuring fewer than 1000 interface range names. Examples # Add Ten-GigabitEthernet 1/1/5 through Ten-GigabitEthernet 1/1/10 to interface range named myEthPort, and enter the interface range view. system-view [Sysname] interface range name myEthPort interface ten-gigabitethernet 1/1/5 to ten-gigabitethernet 1/1/10 [Sysname-if-range-myEthPort] # Enter the view of interface range named myEthPort. system-view [Sysname] interface range name myEthPort [Sysname-if-range-myEthPort] 46