HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 150
loopback-detection interval-time, Usage guidelines, Example, Related commands, Syntax, Default, Views
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Usage guidelines Use this command to enable loop detection globally. To enable loop detection on a specific port, use the loopback-detection enable command in interface view. The global configuration applies to all ports in the specified VLAN. The per-port configuration applies to the individual port only when the port belongs to the specified VLAN. The per-port configuration takes precedence over the global configuration. Example # Globally enable loop detection for VLAN 10 through VLAN 20. system-view [System] loopback-detection global enable vlan 10 to 20 Related commands • display loopback-detection • loopback-detection enable loopback-detection interval-time Use loopback-detection interval-time to set the loop detection interval. Use undo loopback-detection interval-time to restore the default. Syntax loopback-detection interval-time interval undo loopback-detection interval-time Default The loop detection interval is 30 seconds. Views System view Predefined user roles network-admin Parameters interval: Sets the loop detection interval (in seconds) in the range of 1 to 300. Usage guidelines With loop detection enabled, the device sends loop detection frames at the specified interval. A shorter interval offers more sensitive detection but consumes more resources. Consider the system performance and loop detection speed when you set the loop detection interval. Example # Set the loop detection interval to 10 seconds. system-view [Sysname] loopback-detection interval-time 10 Related commands display loopback-detection 143