HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 198
lldp agent nearest-nontpmr admin-status, lldp check-change-interval, Views, Predefined user roles
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
Views Ethernet interface view Predefined user roles network-admin Parameters disable: Specifies the Disable mode. A port in this mode cannot send or receive LLDPDUs. rx: Specifies the Rx mode. A port in this mode can only receive LLDPDUs. tx: Specifies the Tx mode. A port in this mode can only send LLDPDUs. txrx: Specifies the TxRx mode. A port in this mode can send and receive LLDPDUs. Examples # Configure the LLDP operating mode as Rx for FortyGigE 1/1/1. system-view [Sysname] interface fortygige 1/1/1 [Sysname-FortyGigE1/1/1] lldp admin-status rx lldp agent nearest-nontpmr admin-status Use lldp agent nearest-nontpmr admin-status to specify the operating mode for the LLDP nearest non-TPMR bridge. Use undo lldp agent nearest-nontpmr admin-status to restore the default. Syntax lldp agent nearest-nontpmr admin-status txrx undo lldp agent nearest-nontpmr admin-status Default The operating mode for an LLDP nearest non-TPMR bridge is disable. Views Ethernet interface view Predefined user roles network-admin Parameters txrx: Specifies the TxRx mode. A port in this mode can send and receive LLDPDUs. Examples # Configure the operating mode for the LLDP nearest non-TPMR bridge as TxRx on FortyGigE 1/1/1. system-view [Sysname] interface fortygige 1/1/1 [Sysname-FortyGigE1/1/1] lldp agent nearest-nontpmr admin-status txrx lldp check-change-interval Use lldp check-change-interval to enable LLDP polling and set the polling interval. 191