HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 199
lldp compliance admin-status cdp, Syntax, Default, Views, Predefined user roles, Parameters, Examples
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
Use undo lldp check-change-interval to disable LLDP polling. Syntax lldp check-change-interval interval undo lldp check-change-interval Default LLDP polling is disabled. Views Ethernet interface view Predefined user roles network-admin Parameters interval: Sets the LLDP polling interval in the range of 1 to 30 seconds. Examples # Enable LLDP polling on FortyGigE 1/1/1 and set the polling interval to 30 seconds. system-view [Sysname] interface fortygige 1/1/1 [Sysname-FortyGigE1/1/1] lldp check-change-interval 30 lldp compliance admin-status cdp Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP. Use undo lldp compliance admin-status cdp to restore the default. Syntax lldp compliance admin-status cdp { disable | txrx } undo lldp compliance admin-status cdp Default CDP-compatible LLDP operates in disable mode. Views Ethernet interface view Predefined user roles network-admin Parameters disable: Specifies the disable mode, where CDP-compatible LLDP cannot receive or transmit CDP packets. txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets. Usage guidelines You must enable CDP-compatible LLDP globally and then configure CDP-compatible LLDP to operate in TxRx mode on the specified ports. 192