HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 164
port hybrid pvid
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
Examples # Assign FortyGigE 1/1/1 to VLAN 3. system-view [Sysname] vlan 3 [Sysname-vlan3] quit [Sysname] interface fortygige 1/1/1 [Sysname-FortyGigE1/1/1] port access vlan 3 port hybrid pvid Use port hybrid pvid to configure the PVID of the hybrid port. Use undo port hybrid pvid to restore the default. Syntax port hybrid pvid vlan vlan-id undo port hybrid pvid Default The PVID of a hybrid port is VLAN 1. Views Ethernet interface view, aggregate interface view, S-channel interface view Predefined user roles network-admin Parameters vlan-id: Specifies a VLAN ID in the range of 1 to 4094. Usage guidelines You can use a nonexistent VLAN as the PVID for a hybrid port. If you remove the PVID of a hybrid port with the undo vlan command, the setting of the PVID on the port is not affected. HP recommends that you set the same PVID for the local and remote hybrid ports. You must configure the hybrid port to allow and forward packets from the PVID by using the port hybrid vlan command. • The configuration made in Ethernet interface view applies only to the port. • The configuration made in aggregate interface view applies to the aggregate interface and its aggregation member ports. { If the system fails to apply the configuration to the aggregate interface, it stops applying the configuration to aggregation member ports. { If the system fails to apply the configuration to an aggregation member port, it skips the port and moves to the next member port. • The configuration made in S-channel interface view applies only to the interface. Examples # Configure VLAN 100 as the PVID of the hybrid port FortyGigE 1/1/1, and assign FortyGigE 1/1/1 to VLAN 100 as an untagged member. system-view 157