HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 2 - LAN Switching Command Refer - Page 179

LLDP commands dcbx version Use dcbx version to configure the DCBX version. Use undo dcbx version to restore the default. Syntax dcbx version { rev100 | rev101 } undo dcbx version Default Views The DCBX version is autonegotiated by two interfaces, with DCBX Rev 1.01 as the initial version for negotiation at the local end. Layer 2 Ethernet interface view Predefined user roles network-admin Parameters rev100: Specifies DCBX version Rev 1.00. rev101: Specifies DCBX version Rev 1.01. Usage guidelines To make sure DCBX operates correctly, you must configure the same DCBX version that is supported on both ends. H3C recommends that you configure the highest version (Rev 1.01, Rev 1.00 in descending order) that is supported on both ends. After this command is configured, an interface includes the configured DCBX version in its outgoing LLDPDUs and does not negotiate the DCBX version with the peer interface. Examples # Configure the DCBX version as DCBX Rev 1.01 on interface TwentyGigE 1/0/1. system-view [HP] interface twentygige 1/0/1 [HP-TwentyGigE1/0/1] dcbx version rev101 display lldp local-information Use display lldp local-information to display the LLDP information to be sent, which will be contained in the LLDP TLVs and sent to neighboring devices. Syntax display lldp local-information [ global | interface interface-type interface-number ] 172