HP NetServer AA 4000 HP NetServer AA 6200 Solution Release 3.0 Administrator&a - Page 194
SCSI Parameter Mappings in the Windows NT Registry, Windows NT Registry on the IOP
View all HP NetServer AA 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Chapter 6 Configuration Utility Refer to Chapter 2 in the HP NetServer AA Solution Installation Guide for more information about installing and configuring SCSI adapters. To confirm a SCSI device address using the Windows NT Registry on the IOP: Step 1 2 3 4 5 6 Action Notes Open the Windows NT Registry. Choose HKEY_LOCAL_MACHINE\HARDWARE\ DEVICEMAP\Scsi. Choose the SCSI Port for your adapter. Choose \Scsi Bus x\Target ID x\Logical Unit ID x On the right side of the Registry window, make sure that the Identifier and Type parameters describe the SCSI device that you want to add. Map the Registry information to the SCSI parameters that you need to provide in the Endurance Configuration Utility, as described in Table 6-3. If you are using multiple adapters, check the Driver parameter (on the right side of the Registry window) to make sure that you choose the correct adapter. Table 6-3 describes the SCSI parameter mappings to the Windows NT Registry entries. Table 6-3 SCSI Parameter Mappings in the Windows NT Registry Registry Entry SCSI Port number SCSI Bus number Target ID Initiator ID Logical Unit Maps to this Endurance Configuration Utility SCSI Parameter SCSI Adapter Number SCSI Bus Number Target ID. Note that the terms "Target ID" and "SCSI ID" mean the same thing. Initiator ID. The ID used by the SCSI adapter. LUN 178